askö FIRE KEEPER, long cuff

A firefighting glove from the Fire Keeper series.
The series is suitable for use in direct firefighting (flash-over, interior attack) including rescue and extrication in accordance with DIN EN 659.

• 100% aramid in palm, finger joint; additionally with flame-resistant silicone-carbon coating
• Back of hand and cuff made of 100% aramid with seam protection and FC finish
• Inner lining of the cuff 100% cotton
• Porelle membrane insert: waterproof, windproof, optimally breathable and anatomical
• Washable up to 60° C degrees
• Half rings and snap hooks
• reflective textile foil (yellow/silver/yellow) on cuff 50 mm
• with adjustment strap and Velcro fastener

Available sizes: 6-12
Oversize surcharge: from size 12

Performance levels according to EN 659
Abrasion resistance: 3
Cut resistance: 5
Tear resistance: 4
Puncture resistance: 3
Burning behavior: 4
Dexterity: 5

DIN EN 659:2008 (EN 659+A1+AC:2009) CAT III

Note: A "visual inspection" of the gloves should always be carried out before and after each use:

• Is the leather damaged?
• Are there any open, chafed areas in the material, tears etc.?
• Are the seams closed?
• Is the inner lining coming loose?
• Is the glove contaminated with oil?

To ensure the protection of the glove wearer, the following must be checked
a damaged or defective glove must be replaced, even if it is only used
even if it has only been used once!